Ok finally
we're ready to apply our lace!
Copy
a piece of your 3 pleated 100 high lace and paste it to the Gold Heart
Image as a New Layer, select your Deformation tool, position as shown
then holding down shift, begin nudging the corners.
On the
positioning I kind of imagined a straight line on the edge of my heart,
and placed the lace, then while nudging I was able to manipulate it
around the curves, repeat this process until you have layered 7 pieces
of lace to complete the right side of the heart.
Here
we go, Look carefully at the positioning as well as the deforming
outlines of the tool!
In position.......
After
nudging ready to push apply.
You may also find
the need to use the Mover tool to make the final placement just right.
Piece
2
(and these will all be on separate layers as you paste each piece
as a New Layer)
In position.......
After
nudging ready to push apply.
Piece
3
In position.......
After
nudging ready to push apply.
Notice
before you push apply your nodes next to the heart need to be aligned
to create the bend appearance. Use the heavy white line in the lace
as a guide as well :o) Your trying to keep all these lines even at
the same distance, once you place 2 or 3 you'll have the feel of it!
